> Wondering if anyone has any servicing experience with Technogym
> equipment

Brent, your experience is very much like that I had with a friend's Neolt
board cutter. $2000+ for a fairly simple motor controller board and a
"talk to the hand" attitude from the Italian manufacturer. After giving it
the once-over I was quite confident it could have been done with a PIC
from this century. Eventually one of her servicemen offered to do it with
PLCs. Which he did. But didn't finish the job and buggered off leaving
some functions not working and the laser crooked
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist