Renzo Giurini wrote:
> In using Eagle in order to place all components in only one layer I
> try to use the component jumper.
> This component is market or like a resister with 0 resistor, that
> could be correct, or in different way.
> In both cases making th board the behavior does't seems to be a
> connection between two router of the same name.
> There is some trick to use?

It's a bit hard to decipher what you wrote, but you can't expect Eagle to
automatically break up a net and add a jumper component.  You can manuall
break up nets in your schematic with jumpers, and these jumpers can be two
pads spaced some distance apart if you like.


********************************************************************
Embed Inc, Littleton Massachusetts, http://www.embedinc.com/products
(978) 742-9014.  Gold level PIC consultants since 2000.
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist