In SX Microcontrollers, SX/B Compiler and SX-Key Tool, Cenlasoft wrote:

Hello,
I was given this code by Terry a while ago. This was to create a square wave.

Device SX28, Oschs2, Turbo, OptionX, StackX

Freq 50_000_000

OutPin Pin RA.0 Output

Interrupt NOCODE 434_782      '217 khz

OutPin =~ OutPin
Returnint

Program Start

Start:
End

It works fine but is it possible to sweep a frequency range in this interrupt?
I want to start at 180 khz and end at about 225 khz

How many steps can this code do between the stated range?

Thanks,
Cenlasoft

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=331570

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2009 (http://www.dotNetBB.com)