cdb wrote:
>  I am using pin RC1 as a PWM output.
> 
> In the program setup I initialise  PR2 and set CCPRL2 to zero, RC1 has 
> previously been set up as an output. I do not switch the PWM module on 
> in this part of the code.

So the bottom 4 bits of CCP2CON are 0? That should disconnect PWM from RC1.

Cheers,

Bob

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist