solarwind wrote:
> I've watched multiple videos on this and haven't come up with an answer yet.
>
> Are you supposed to sand the copper clad board before transferring the
> design when making your own PCB? If so, why? If not, why not?
>
>   
I use a nylon scouring pad (the green ones)
and just scrub the board until its "bright"

give it a rinse in hot water and dry it while its hot.
then straight away start with the ironing.
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist