Randy Glenn <randy <at> surrealitylabs.com> writes:
> I've posted a photo of the binding post without the plastic Keystone jack 
>frame:
...

I have used similar posts before. Solderability is sometimes a problem due to
the 'pretty' plating. Using fine abrasive paper and then rosin flux on the
solderable 'pin' helps usually. The post is meant to be have the wire wrapped
around it in one turn and then soldered. Be sure to remove the item from the
plastic holder before soldering, it takes a lot of heat and it will destroy the
plastic if it is attached.

Peter


-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist