In SX Microcontrollers, SX/B Compiler and SX-Key Tool, Brian218 wrote:

I'm just starting to learn assembly and I'm puzzled by an apparent difference between SX/B and assembly. 
I'm using the PDB ans SX-Key.

With a SX/B program, after downloading/running, it stays in the SX chip's memory and will start running if the power is turned off and then turned back on.

When I run the attached program, it runs as expected until the power is turned off and then turned on. After the power is turned back on, it does not run.

Is this normal? 
How would I get it to start running at power-on?

The program is a simple program that increments RB.

Thanks in advance!

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=323069

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2009 (http://www.dotNetBB.com)