solarwind wrote:

> Now, if I obviously can't do 4 layer PCBs, but double sided shouldn't
> be any harder than single sided. Just have to iron both sides, don't
> I? 

It's fine for crude stuff. But you can't get all four corners to
register exactly. Also, laser printers go faster and slower as the paper
goes through. So even if you could get all four corners to line up, in
between there would be registration errors between the two sides. But if
you are careful you can do coarse stuff on smallish boards.

Hey, go for it. You will see what the limitations are and if you're
doing the layout yourself you can design accordingly. Use big vias with
room around them. Or get good at drilling slanted holes :)

Best regards,

Bob
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist