Andre Abelian wrote:
> I am familiar with this issue it happened with me a few times.
> 1. Change your configuration to set master clear internal then program
> it
>   If it worked then you do not have pull up on reset pin.

Isn't MCLR controlled by ICD2 in Programmer mode? "Release from reset" puts 
the MCLR line into high state.

> 2. if above didn't help then you need to add 0.1uf caps on the board
>    you do not have it enough decoupling caps. When you plug ICD it adds
>    caps for you.

>From Matt's description, it sounds like ICD2 is connected to the target in 
Programmer mode, so this can't be it either.

Vitaliy 

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist