> .
> 
> What kind of wire should I use for prototyping on Veroboards? For

> All I know about wire is that there are single stranded, multiple
> stranded, thin and thick and a whole bunch of specialty types. Which
> should I use for Veroboards? I don't want the wire occupying half the
> board so I think it should be pretty thin, and I think I should get
> the multiple stranded type for flexability. Also, I think the multiple
> stranded copper wire will allow the solder to get between the gaps in
> the wire easier, but I'm not too sure on this. What are your opinions
> on this?
Solid strand for sure. It doesn't bunch up through a hole, and you can
route it by hand with whatever corners are needed.
How much board is occupied by wires is determined by the distance
between holes not wire diameter. Unless you use big wire like mains
cable.

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist