On Mon, Dec 15, 2008 at 11:58 PM, Bob Blick wrote: > And you still need to keep the VPP/MCLR pin restrained no matter if it > is enabled or not. Because if it goes over some number of volts you > enter programming mode. But you know that already, right? Yes. > Oh, and you already know about the low voltage programming pin, too, right? Yes. Seriously I did because I read the part on ICSP when I was setting up the ICSP on my breadboard. -- ..::[ solarwind ]::.. -- http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist