but when you reflow the board, will the components on the bottom side fall off at high temp? Funny N. Au Group Electronics, http://www.AuElectronics.com ________________________________ From: Wouter van Ooijen To: Microcontroller discussion list - Public. Sent: Sunday, December 7, 2008 4:33:50 PM Subject: Re: [EE] Make Your Own PCB Funny NYPD wrote: > You can use some water-soluble glue for two side SMD components. As I said, no need for that when using a paint stripper. The main problem is stenciling the paste on the top side when the bottom side already has components. -- Wouter van Ooijen -- ------------------------------------------- Van Ooijen Technische Informatica: www.voti.nl consultancy, development, PICmicro products docent Hogeschool van Utrecht: www.voti.nl/hvu -- http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist -- http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist