In SX Microcontrollers, SX/B Compiler and SX-Key Tool, eagletalontim wrote:

No, MotorA does not always run at half speed.  Sometimes it is 1/4 sometimes 3/4 and so on depending on the PWM output.  I need to be able to press a button connected to the chip and the code start MotorA at the predefined speed, then activate the other motors after MotorA has been activated.  A delay will be set after all motors are on and when the delay is ended, MotorA will be turned off.

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=310134#m310155

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2008 (http://www.dotNetBB.com)