Andre Abelian wrote:
> I am doing PCB layout that has 12v and 5v. 12v has 2A load
> and it is used to power leds and 5v is to supply logic.
> The board is only 4 layers and I am not sure about power plane
> Should I use 12v as part of power plane or 5v.

If they all have a common ground, make layer 3 the ground plane and route
everything else as needed.  It's rarely necessary to use planes for power.


********************************************************************
Embed Inc, Littleton Massachusetts, http://www.embedinc.com/products
(978) 742-9014.  Gold level PIC consultants since 2000.
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist