Just do a bare bones board from your neighbors there (Advanced).

For not so tight pitched parts, I just super glue them down to a piece of cardboard and use bell wire


--- On Tue, 11/11/08, Michael Algernon <pic@nope9.com> wrote:

> From: Michael Algernon <pic@nope9.com>
> Subject: [EE]: Advice on breadboarding SMD parts
> To: "Microcontroller discussion list - Public." <piclist@mit.edu>
> Date: Tuesday, November 11, 2008, 10:03 PM
> I have some parts with 0.65 mm lead spacing and 0.5 mm lead
> spacing.
> They are dual inline packages.
> Where could I get some PCBs that make working these parts
> easier ?
> I have SMD parts with 0.05 inch lead spacing covered.
> 
> MA
> 
>   WFT Electronics
> Denver, CO   720 222 1309
> " dent the UNIVERSE "
> 
> All ideas, text, drawings and audio , that are originated
> by WFT  
> Electronics ( and it's principals ),  that are included
> with this  
> signature text are to be deemed to be released to the
> public domain as  
> of the date of this communication .
> 
> -- 
> http://www.piclist.com PIC/SX FAQ & list archive
> View/change your membership options at
> http://mailman.mit.edu/mailman/listinfo/piclist


      
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist