In SX Microcontrollers, SX/B Compiler and SX-Key Tool, jecuzens wrote:

[quote="JonnyMac"]The problem is that the PWM command leaves the LED pin in an input state -- change [b]Led = 1[/b] to [b]HIGH Led[/b].

From the help file PWM page:
[i]After outputting the PWM pulses, the SX leaves the pin in input mode... [/i][/quote]

Sweet! Thanks! I was pulling my hair for a little bit there! Thanks for the help!

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=305945#m305965

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2008 (http://www.dotNetBB.com)