the price doesn't sounds about right when you order 100 pieces.

 Funny N.
Au Group Electronics, New Bedford, MA, http://www.AuElectronics.com



----- Original Message ----
From: limor <ladyada@gmail.com>
To: Microcontroller discussion list - Public. <piclist@mit.edu>
Sent: Wednesday, September 10, 2008 8:34:56 PM
Subject: Re: [EE] low cost pc board house for prototype???

http://www.ladyada.net/library/pcb/costcalc.html
should be pretty close

On Wed, Sep 10, 2008 at 5:49 PM, Ray Newman <list@microdesigns.biz> wrote:
> I am so embarrassed.
> Been in discussions about pc board houses before but never needed one for 1-2 boards before so I never saved info.
> Please forgive me.
>
> I need to make 1-2 piece pc board
> 2.5" x 3.5"
> double sided
> plated through holes
> solder mask two sides
> silkscreen one side
> FR4
>
> 0.020" trace min.
> 0.020" clearance
> 0.020" min. hole size
>
> I have old style gerbers that has separate pad stack info file
> tango
>
> who do you suggest to make one or two boards?
>
> My standard supplier will make me three panel 8" x 10" with as many boards I cam stuff on it (they route for me for free)
> BUT
> $350 min. charge.
>
> I need to lower this cost as far as I can because I have to do it for free.
>
> Any suggestions??
>
> Need in less than one week.
>
> Thanks,
> Ray
>
>
> --
> http://www.piclist.com PIC/SX FAQ & list archive
> View/change your membership options at
> http://mailman.mit.edu/mailman/listinfo/piclist
>
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist



      
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist