http://www.4pcb.com is huge and getting bigger by the minute. They are
fast and inexpensive for what you get.

But your boards have to pass their DFM check first, otherwise forget it,
your boards will be delayed at least once.

Fortunately they have an online DFM checker.

Yes, I've used them before but I'm not a stockholder. They are like the
Microsoft of PC boards so some people hate them.

So far I haven't found the Ubuntu of PC boards although I'd love to find
them :)

Cheerful regards,

Bob

Ray Newman wrote:
> I am so embarrassed.
> Been in discussions about pc board houses before but never needed one for 1-2 boards before so I never saved info.
> Please forgive me.
> 
> I need to make 1-2 piece pc board
> 2.5" x 3.5"
> double sided
> plated through holes
> solder mask two sides
> silkscreen one side
> FR4
> 
> 0.020" trace min.
> 0.020" clearance 
> 0.020" min. hole size
> 
> I have old style gerbers that has separate pad stack info file
> tango
> 
> who do you suggest to make one or two boards?
> 
> My standard supplier will make me three panel 8" x 10" with as many boards I cam stuff on it (they route for me for free)
> BUT
> $350 min. charge.
> 
> I need to lower this cost as far as I can because I have to do it for free.
> 
> Any suggestions??
> 
> Need in less than one week.
> 
> Thanks,
> Ray
> 
> 
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist