PicDude wrote:
> The bummer about pcb-gcode is that is does not have tool-bit
> offset/compensation.  Yes, I've used it successfully by drawing additional
> lines for the actual cutter path that I offset by the correct radius of the
> tool-bit, but it would be nice if it did it automatically.  Or perhaps I
> somehow missed the setting in the config screen?

I haven't used it myself - just lurked for a while before I decided not 
to go in the direction of milling my own PCBs - but it does seem like 
it's actively supported, and I bet you could get that question answered 
on the forum.
-- 
Timothy J. Weber
http://timothyweber.org
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist