In SX Microcontrollers, SX/B Compiler and SX-Key Tool, Chet wrote:

These are the files I have,  They came with the UART/I2C board.  I have tried it on the board as it came, but I have not experimented with it.  If the slave processor can look for it's information on the bus via some handshaking, then the I2C commands should be doable in SX/B.  There are some examples scattered around with handshaking like !ABC ....  where the !ABC is the slave device address.
 

Good luck.

 

Chet

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=286276#m286289

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2008 (http://www.dotNetBB.com)