In SX Microcontrollers, SX/B Compiler and SX-Key Tool, wikst wrote:

My power supply that was a little higher than the 5V I had turned it to, so after turning it down to 4.5V and adding the cap and 10kOhm it worked fine to progam my chip.

Thx a lot Bean!

/esa

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=275873#m276126

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2008 (http://www.dotNetBB.com)