In SX Microcontrollers, SX/B Compiler and SX-Key Tool, capdiamont wrote:

Got home late last night, so started troubleshooting today after work. Found problem, just need to fix timing.

Both power supplies are plugged in to wall. Check. I have one I use for programming, the other is 24vAC transformer. Will be making it all run off the 24vAC transformer.
Got out cheap multimeter, voltage good, 24vAC. The device can handle 60vAC or DC
Amperage, to low for cheap meter's 10a only range. Thus good.
Brought out better meter, max amperage measured on 2ma scale was 0.036 amps. Well under one amp the device can handle.
Time to open up the casing.
No LED lit on the SX protoboard.
Switch in in "0". Grumble
Moved switch to "1". Soon each zone activates in turn, though with only about 5 to 6 min on time, and shuts off. 

Other than on time being off, it works great. Time to wire up the LED's and shove the programming I've done while gone to the SX.

My thinking on the BREAK is that it stops the program and I don't want to stop the program, just watch to make sure the variables are doing what I want them to do. Just poll once in a while.

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=273648#m274390

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2008 (http://www.dotNetBB.com)