2008/6/12 Sergey Dryga <register@dryga.us>:
> Philip Pemberton <piclist <at> philpem.me.uk> writes:
>>
>>    There's far too much ink around the hole after filling to use any form of
>> sticky tape, and what little I remove just leaks out again once I put the tape
>> back on. I'd also rather not use hot melt glue as it's likely to be "a bit"
>> difficult to remove and the heat might boil away the ink and fudge the
>> chemistry up. Plus it's not exactly easy to cut it down to fit in the printer
>> without breaking the seal.
>
> How about using a piece of playdough?  There is not pressure, you just need to
> prevent ink from spilling and drying up, right?
>
> Sergey Dryga
>
> www.beaglerobotics.com
>


Or chewing gum,  or "that plastic you soften in hot water" ??

RP
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist