Philip Pemberton <piclist <at> philpem.me.uk> writes:
> 
>    There's far too much ink around the hole after filling to use any form of 
> sticky tape, and what little I remove just leaks out again once I put the tape 
> back on. I'd also rather not use hot melt glue as it's likely to be "a bit" 
> difficult to remove and the heat might boil away the ink and fudge the 
> chemistry up. Plus it's not exactly easy to cut it down to fit in the printer 
> without breaking the seal.

How about using a piece of playdough?  There is not pressure, you just need to
prevent ink from spilling and drying up, right?

Sergey Dryga

www.beaglerobotics.com



-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist