You might consider looking at
http://www.protomold.com
for short run injection molding and
http://www.firstcut.com/
for short run plastic machining (ie, setup cost is significantly less
than injection molding, but per part cost is higher)

-Adam

On 6/9/08, Djula Djarmati <piclist@sbb.co.yu> wrote:
> > 2. Any ideas on how I could get plastics made for this thing? Maybe
> > something like a snap together case, or a rubberized soft shell or
> > something.
>
> I asked our plastic manufacturer for a rough price. He says a 5x2cm
> USB-disk type enclosure tooling cost is $2500-$3500 and the
> manufacturing of 1000 pieces would be $350-$700. This is in Serbia.
>
> Please let us know about the outcome.
>
> Djula
> --
> http://www.piclist.com PIC/SX FAQ & list archive
> View/change your membership options at
> http://mailman.mit.edu/mailman/listinfo/piclist
>


-- 
EARTH DAY 2008
Tuesday April 22
Save Money * Save Oil * Save Lives * Save the Planet
http://www.driveslowly.org
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist