In SX Microcontrollers, SX/B Compiler and SX-Key Tool, CrustyNoodle wrote:

Well I'm really starting to get into this whole micro thing and enjoying it a lot.  My ultimate aim is to build an inertia dyno to test and tune RC car engines and my SX project will do the data acquisition and a bit of servo control.
 

I've done a fair bit of searching on the forum now and haven't yet found a clear solution to the SX to PC communications using USB.  As I only have laptops with USB ports I'd like to find a solution that enables me to communicate using USB without the need to use a USB to RS232 type of device.  Ultimately I'd like a device that has a USB recepticle that I can plug into the bread board area of my SX Tech Board that then allows me to address it directly using my SX.

 

Does anybody know if there is such a beast in existence and if not then any suggestions on how best to do this?

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=271442

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2008 (http://www.dotNetBB.com)