Make sure you know if you are running target from ICD2 (it is a 
setting).  You have a choice there.   I have had better luck with 
separate supplies.
Check the voltage in the settings too, refresh it.  Do you have a big 
cap on the reset line?  I use 47-100K and a 1.uF for reset parts?



Stephen D. Barnes wrote:
> I have an ICD3 (R23) that will not release the target chip from reset. 
> While in reset, it holds the MCLR at 0V. When releasing from reset, it 
> only allows MCLR to rise to approx. 1.8 to 2.1V. I am using the 
> recommended diode/resistor combo from VDD to MCLR. Does anyone have 
> suggestions as to what may have failed in the ICD2 to cause this?
>
>   
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist