spam@maksimov.org wrote:
> Quoting "Stephen D. Barnes" <stephendbarnes@cavtel.net>:
>   
>> I have an ICD3 (R23) that will not release the target chip from reset.
>> While in reset, it holds the MCLR at 0V. When releasing from reset, it
>> only allows MCLR to rise to approx. 1.8 to 2.1V. I am using the
>> recommended diode/resistor combo from VDD to MCLR. Does anyone have
>> suggestions as to what may have failed in the ICD2 to cause this?
>>     
>
> Does this happen when the ICD2 is connected to the target, or even  
> when it's not
> connected?
>
> IIRC, Microchip will replace the hockey puck free of charge.
>
> Vitaliy
>
>   
It does not matter if it is connected to the target or not. Will they 
replace it out of warranty? This unit is over 2 yeas old but has been 
well cared for and not electrically or physically abused.

-- 
Regards,
Stephen D. Barnes

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist