In SX Microcontrollers, SX/B Compiler and SX-Key Tool, Peter Van der Zee wrote:

Hi Bill;

As ROBOT said, without your code posted it is difficult for any of us to help much; however, if it is I/O that is troubling you in moving from the SX28 to the SX48 then I suspect you have overlooked the differences in the M codes for setting up the direction (and other) I/O registers. The SX28 uses M=$0F and the SX48 uses M=$1F.

Cheers,

Peter (pjv)

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=269265#m269276

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2008 (http://www.dotNetBB.com)