I have a dsPIC30F2010 as the target with ICD2 connected. The MCLR pin 
has the usual 10K resistor and schottkey diode to VDD (+5V). With the 
ICD2 connected to the circuit and held in reset, voltage at the MCLR pin 
is 0V as expected. When I release from reset, the MCLR pin only comes up 
to +1.7 V. If I disconnect the ICD2 VPP line from MCLR, the voltage on 
the MCLR pin rises to 4.9V. I believe this indicates the ICD2 is at 
fault. Has anyone else had this issue? BTW the ICD2 is P/N 10-00319 R23.

-- 
Regards,
Stephen D. Barnes

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist