I really like the Hammond 1455 series and was looking for something
similar at a lower cost.  I don't really care about the anodized finish.
This is for hobby work.

Anyway, found some enclosures made by Context Engineering at a local
Fry's Electronics.  It's their split body line:

http://www.contextengineering.com/split_body_enclosures.html

Cost is less than the Hammond but I'm buying the brushed aluminum finish
-- not anodized.  They will anodize for you and provide a number of
custom options.

I checked with the manufacturer and they will sell small quantities (as
few as one) however I didn't get a price from them.  There are a number
of other retailers online that sell their enclosures as well.

-Jeff


> Chris Smolinski <csmolinski@blackcatsystems.com> wrote:
>   I'm looking for a source for some small metal enclosures, something 
> along the lines of the Hammond 1455 series, but a little less 
> expensive. I'm not terribly picky about the size, around an inch high 
> by 3 or 4 inches wide and deep would be fine, but I'm flexible. Any 
> suggestions at who/where else to look?


-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist