Depending on qty, you might check with a local sheet metal vendor. The last project I needed some boxes for, and it was only 16, it was less expensive to have someone punch, bend and powder coat than it was to puchase something off the shelf and then drill and punch after. Chris Smolinski wrote: I'm looking for a source for some small metal enclosures, something along the lines of the Hammond 1455 series, but a little less expensive. I'm not terribly picky about the size, around an inch high by 3 or 4 inches wide and deep would be fine, but I'm flexible. Any suggestions at who/where else to look? -- --- Chris Smolinski Black Cat Systems http://www.blackcatsystems.com -- http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist --------------------------------- Be a better friend, newshound, and know-it-all with Yahoo! Mobile. Try it now. -- http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist