In SX Microcontrollers, SX/B Compiler and SX-Key Tool, Ugha wrote:

Zoot:
I tried your version of the program using a 4mhz res with little result... at least the no-signal LED flashes now.
I changed the OSC4MHZ to OSCXT2.

JonnyMac: I attempted your program too, again, with a 4Mhz res with no luck. The no-signal LED doesn't even flash.

I tripple checked my wiring and again hooked it up exactly the same to a BS2 on a BOE with the previously attached program
and it works fine.

The only thing I haven't mentioned so far is that I am running the SX tech board off 4 AAs... although I strongly doubt that
matters.

Anyone have any ideas?

I'm attaching the program I use on a second BOE to generate the RF signal that I'm trying to get the SX to receive... just in
case the problem might be there.

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=264135#m264250

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2008 (http://www.dotNetBB.com)