Harold Hallikainen wrote:
> few operands ('bclr lmot_dir')
>   
>> I also tried using LATE,0 in the define and the code with the same
>> results. Why is giving a custom name
>> to a port pin in ASM30 such an ordeal. I can just use BCLR PORTE, #0 and
>> it works fine but a clearly
>> defined name for the pin makes for readable code.
>>
>>     
>
> I think that's it! You need to tell it that it's a literal, so you use #0
> instead of 0. This has caught me before on writing for the 24H. So, maybe
> something like this works:
>
> #define LED LATE,#0
>
> then do
>
>     blcr LATE
>
> Note that I think you should use LATE instead of PORTE to avoid read
> modify write issues. LATE is the internal output latch, so it reads THAT,
> modifies it, then writes it back to the latch. It does not care what the
> actual pin is doing (which using PORT does do).
>
> Harold
>
>
>
>   
Using LATE is good advice that I will use. The code does not work even 
with the define using
the ,#0. Thanks for the reply.

-- 
Regards,
Stephen D. Barnes

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist