Aha! That points me in the right direction.
Thank you very much.

Djula Djarmati wrote:
> Stephen D. Barnes wrote:
>   
>> I am working with the dsPIC30F2010. This chip is new to me. I have read 
>> the data sheet..family ref, etc.
>> I have configured RE8 as an external interrupt (INT0) on rising edge. 
>> When the interrupt occurs the the correct
>> interrupt flag is set and the chip then goes to what appears to be the 
>> start of the program. I am using
>> the assembly template that Microchip supplies with MPLab. How exactly 
>> does one create an ISR for the
>> dsPIC? In the 16F series it was an ORG <address> and that's where the 
>> ISR went. The dsPIC interrupt vector
>> table says the address is 0x000014. I'm lost. Any pointers in the right 
>> direction would be appreciated.
>>     
>
> You don't need to mess with interrupt vector table manually, you just 
> use the predefined interrupt labels from linker script (i.e. p30f2010.gld).
> I'm sure an example can be found in Microchip templates somewhere.
>
>
> Example for TMR1 interrupt:
>
> __T1Interrupt:  PUSH.S                  ;TMR1 INT each 1ms, save context
>                  BCLR    IFS0, #T1IF     ;Clear TMR1 interrupt flag
>
> 		NOP                     ;Do something useful
>
> EndIntTMR1:     POP.S                   ;Restore context
>                  RETFIE			;Done
>
>
> Djula
>   


-- 

*Regards,*

*Stephen D. Barnes*

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist