In SX Microcontrollers, SX/B Compiler and SX-Key Tool, bean wrote:

Gunther,
  I have found a quirk in SX-Sim 2.08.06. 
  Pin RB.1 was in input and I right clicked it to make it read high.
  Then in the code RB.1 was made an output and low.
  Later in the code RB.1 was made an input again. But it still reads as low even though on the I/O panel it is green.
  If i click on RB.1 and turn it off then back on again, it works correctly (until the next loop).

  You can see in the picture that RB.1 is green, but in the registers window it says RB is $00 (all off).

Bean.

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=10&m=53539#m256875

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2008 (http://www.dotNetBB.com)