Hi Harold, the same experience here. I found out that even it seems to
be disabled it's actually enabled and works fine so I guess it's only
one of the hundreds of visualistion problems in 8.x. Tamas

On 3/3/08, Harold Hallikainen <harold@hallikainen.org> wrote:
> I'm working on a PIC24 project using MPLAB 8.01 and C30 in the MPLAB
> simulator. I'm finding that if I double click on a line of code, I can
> bring up a disabled breakpoint (red circle), but cannot bring up an
> enabled breakpoint (red circle with B in it). I've seen this before if
> I've exceeded the maximum number of breakpoints, but remove all
> breakpoints does remove these disabled breakpoints, but does not allow me
> to establish an enabled breakpoint. If I exit MPLAB and restart it, I CAN
> set breakpoints for a while, then it returns to this behavior.
>
> This also happens if I'm debugging with the ICD-2.
>
> I've been using MPLAB for years and 8.01 for a few months and have not
> seen this before.
>
> Ideas?
>
> THANKS!
>
> Harold
>
>
> --
> FCC Rules Updated Daily at http://www.hallikainen.com - Advertising
> opportunities available!
> --
> http://www.piclist.com PIC/SX FAQ & list archive
> View/change your membership options at
> http://mailman.mit.edu/mailman/listinfo/piclist
>

-- 
Sent from Gmail for mobile | mobile.google.com

Rudonix DoubleSaver
Did You Know that DoubleSaver is Smaller and More Powerful FailSafe
Device than Any Other You can Get?
http://www.rudonix.com
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist