In SX Microcontrollers, SX/B Compiler and SX-Key Tool, Steel wrote:

The Great thing about the SX is how simple it is to hook up.

If you want to use an internal oscillator;

You need a GND going to VSS.  You need 3.3V-5V going to VDD.  You will want to tie the RST pin to VDD (with a 10k resistor).

You will want a 4 pin header that connects to OSC1, OSC2, VDD,VSS.

If you look in the manual, there is a 'programming interface' picture that shows this.  It is al you need.

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=250467#m251245

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2008 (http://www.dotNetBB.com)