In SX Microcontrollers, SX/B Compiler and SX-Key Tool, turbo355 wrote:

Thanks for the reply. Yes i am using a 4mhz xtal now i figured i might have to get a special size to be able to do this. This is for a simple program to take a analog voltage on one input pin and compare it to a table then send it out through a single wire to a dash for a temperature gauge. It uses a 7812.5 baud rate with 8bits ,no parity, and 1 stop bit.

I may be able to fudge a little on the baud rate as i dont think the device is super picky on the rate at witch it come in at but 7812 is what the factory ECU used to communicate at.

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=251099#m251112

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2008 (http://www.dotNetBB.com)