In SX Microcontrollers, SX/B Compiler and SX-Key Tool, eagletalontim wrote:

I finally got the chip to boot up with the regulator.  i wound up having to put a 1k resistor from the 12v source to the input of the regulator or it would burn it up.  found that out the hard way :(  
Yes, I just need to turn the motors on/off  I think i figured out that circuit using an NPN and a PNP.  The PNP is rated at 15A so i should not have any problems with it i hope :p

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=243374#m243568

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2008 (http://www.dotNetBB.com)