In SX Microcontrollers, SX/B Compiler and SX-Key Tool, James Newton wrote:

Dude... The datasheet for the SX28 specifies 5.5 volts MAXIMUM supply voltage. That means you MUST have a regulated power supply. 

Also, where is your clock? Did you setup the chip to run on the internal RC oscillator? If so, you do know that runs at something between 3 and 5 KHz, not the standard Mhz right? If you want fast, you must also supply the clock.

Read the datasheet.

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=243374#m243420

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2008 (http://www.dotNetBB.com)