In SX Microcontrollers, SX/B Compiler and SX-Key Tool, RDL2004 wrote:

Those soldered on sockets are are FCI .100" Dubox connectors. They're on page 1245 of the current Mouser catalog at the top of the page (figure B). I used the 2x4 and 2x8 versions. 

The Mouser part numbers are 649-68683-304LF and 649-68683-308LF (they also have basically the same thing from 3M). 

You could probably just use the 1x16 connectors that Parallax sells, you'd have to cut them to get 4 positions but two 1x16 would work about as well as two 2x8. 

If you make one of these be careful that you have enough clearance for the breadboard to fit when you solder on the sockets. Mine isn't even stuck down, but its a tight enough fit that it doesn't fall off even if turned upside down.

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=236524#m240146

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2008 (http://www.dotNetBB.com)