In SX Microcontrollers, SX/B Compiler and SX-Key Tool, PJMonty wrote:

ROBSCIX,

Just run the I/O lines from the SX to the address and chip select lines of the chip you want to control.  You then need to manually put the right values on the I/O lines to set the address and chip select.  Depending on the chip, this is either going to use a bunch of I/O lines or a few.  You'll also need to be aware that need to set the address lines first, and then manipulate the CS line, in order to give the chip time to let the address settle before enabling it.  No trick solution for this, just some manual labor.

Thanks,
PeterM

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=237748#m237759

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2007 (http://www.dotNetBB.com)