In SX Microcontrollers, SX/B Compiler and SX-Key Tool, peterverkaik wrote:

Hi Bean,

Here is my design for a dip18. It is a tight fit. All traces are 12mil, pads are 60x40mil hole 28mil.
Vias are diameter 40mil, hole 20mil. The chip goes to the bottom side.


regards peter

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=233413#m233618

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2007 (http://www.dotNetBB.com)