On Thu, 2007-09-20 at 08:42 -0700, Harold Hallikainen wrote:
> I've got a couple project where we'd like to send some data over 802.11.
> I'm trying a dPac WLNB-AN-DP102-G module, which has an SPI interface.
> Supposedly the SPI port can run at 20MHz, but I can see errors appear (msb
> of ascii output being set) if I have an SPI clock above 750kHz or so. Then
> my throughput through a telnet connection is only about 270kbps.
> 
> Has anyone gotten this module to go faster? Can anyone suggest a similar
> module that will?

Stupid question, but are you 100% sure you have your SPI parameters
correct?

It sounds like clock polarity might be wrong? TTYL

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist