----- Original Message ----- From: "Brad Stockdale" To: Sent: Wednesday, September 19, 2007 12:19 PM Subject: Re: Custom protoboards? > Hello all, > > As you may remember, a few weeks back I asked about EuroCard racks and > protoboards. I looked through my pile of junk and found out that I have > four > pieces of telecomm gear that appear to be using the EuroCard standard. > Unfortunately, they are using an odd size -- 3U x 280mm. As my luck goes, > I > can't find protoboards anywhere that are this size. > > Does anyone know of a place that makes custom protoboards? Basically I > wanted to find somewhere that would make me protoboards with the EuroCard > 96 > pin connector on one side, maybe a DB25 on the opposite side, and > prototyping > area in between... Holes can be plated or not... > > Failing that, maybe I could just use bulk prototyping board, cut it to > size, and hope that the 96 pin connector aligns with the standard hole > patterns... Might be easier to go that way, I suppose. > > Thanks, > Brad > -- Brad, I did a Google search on vme+3u+prototype and got several likely hits. Some have connectors, some don't. Here are a few: http://www.dawnvme.com/ http://www.busboard.net/ http://www.mainelectronics.com/circuitbrd.htm I hope this helps. Richard -- http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist