In SX Microcontrollers, SX/B Compiler and SX-Key Tool, peterverkaik wrote:

Gunther,

I believe SxSim does not handle ret and retp correctly in respect
to the displayed active line.


Single step the attached program and observe stack, PC and PAx whenever
there is a call or ret or retp.
There are deliberate errors in the listing, that is some ret's must be retp
but the point here is that although the PC and PAx are set corectly
after a ret (PAx unchanged) or retp (PAx updated) the active line
jumps to the correct line as the program was intended but I believe
the active line is not at the correct page.

regards peter

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=9&m=53539#m217035

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2007 (http://www.dotNetBB.com)