Hi Spehro,
Is this package feasible to solder by hand?
Best regards
		Luis


-----Original Message-----
From: piclist-bounces@mit.edu [mailto:piclist-bounces@mit.edu] On Behalf
Of Spehro Pefhany
Sent: 30 August 2007 13:18
To: Microcontroller discussion list - Public.
Subject: Re: [EE] 200Mhz CLK for CPLD

At 04:43 AM 8/30/2007, you wrote:
>Hi All,
>I am looking to run a CPLD at 200 MHz and I am finding it difficult to
>generate the CLK signal. I though about using a CLK multiplier, but I
>would like to have a low pin count one, like a 8 pin device SMD if
>possible.
>Any ideas would be appreciated.
>Best regards
>                 Luis

http://www.ctscorp.com/components/Datasheets/008-0321-0_B.pdf

Available programmed from Digikey.

>Best regards,

Spehro Pefhany --"it's the network..."            "The Journey is the
reward"
speff@interlog.com             Info for manufacturers:
http://www.trexon.com
Embedded software/hardware/analog  Info for designers:
http://www.speff.com



-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist