In SX Microcontrollers, SX/B Compiler and SX-Key Tool, JonnyMac wrote:

I was working on a LanC camera controller that took power from the camera, and had an I/O pin connected to the camera's serial I/O pin.  When the camera was told to power down it would, then come back on about two seconds later -- this behavior is indicative of the serial line being shorted to ground, so I suspect that's where my SX I/O went.  In the end I had to use the transistor buffer circuit recommended by Sony in their LanC specification.

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=209772#m209781

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2007 (http://www.dotNetBB.com)