In SX Microcontrollers, SX/B Compiler and SX-Key Tool, Mrudisill wrote:

I am having problems with the vex sx28 controller.  I'm new to the sx family, good bit with bs2.  Am i missing something simple.  I have the sx28 board, the blitz key (for the price diff, just buy the real one if your serious about learning new things) and a few 50 Mhz resonator and some three pin headers.  I loaded the code to the sx, verified that i have ppm input on the input pin.  All outputs are junk very low high frequency wave forms.  I'm not sure if I have the resonator / crystals connected in the right way.  I was hoping i could just load the code and go.  I'm 100% sure is something i'm doing wrong and overlooking.

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=175498#m206345

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2007 (http://www.dotNetBB.com)